Equipment Control
No more need to run cables to control your building
Why use LoRa sensors?
No wiring
Cut down on cable costs and installation time. Install your sensors and actuators in a flash.
Long range
The range of the LoRa radio signal can extend for several kilometers, even through walls and floors.
Radio controls
Send radio commands to control your Enless equipment.
It’s possible to operate a system without running cables
Take advantage of long-range LoRa wireless technology to send commands to Enless sensors and control your devices without any wiring.
All-or-nothing relay (TOR)
LoRa on/off relay control allows you to remotely control your building’s technical equipment without the need for control wiring. When paired with a BMS, the Enless TX IO actuator transmitter—which features 2 inputs and 4 relay outputs and is externally powered—receives control commands via LoRa radio and executes them reliably and instantly.
This solution is ideal for energy management, scheduling, or automated scenarios.
Use cases
- Valves
- Air heaters
- AHU (Air Handling Units)
- Pumps
- Heated floors
Modbus slaves
The Enless Modbus master transmitter supports reading and writing to over 60 registers that can be distributed across 10 Modbus slaves. Using a LoRa transmitter to control Modbus slaves is particularly useful in buildings where cabling is difficult. LoRa technology enables the Modbus master transmitter to send information read from Modbus registers and also to receive write commands for registers that support this functionality. This allows you to control Modbus devices over very long radio ranges without running cables.
Use cases
- Energy meters
- Refrigeration units
- HVAC controllers
- AHU (Air Handling Units)
- Air heaters
Radiators
Achieve precise and responsive heating control with the Enless LoRaWAN thermostatic valve. The thermostatic valve receives radio commands from the BMS control the opening percentage of its motor or to reach a target setpoint temperature. When paired with Enless temperature sensors and your building management system (BMS), it adjusts heating based on the actual needs of each zone. Its battery-powered design enables rapid deployment without major construction or wiring, providing room-by-room control throughout the building. The result: optimal comfort for occupants and a significant reduction in energy consumption.
Setpoint temperature
Control the room temperature remotely or manually.
Long battery life
Up to 10 years of battery life thanks to the 3 AA batteries included with the valve.
Window-opening detection
Automatically detects a change in temperature caused by a window being opened.
Compatible with all radiators equipped with valves
Valve compatible with all radiators thanks to adapters.
Ready to go wireless?
Contact our sales team to learn more about Enless products